adhesive friction
英
美
[网络] 黏著摩擦
双语例句
- Using friction coefficient tester, we have investigated the humility and UV-light dependence of the adhesive force and friction coefficient on glass surface and nano-TiO 2 film coated glass surfaces in the relative humidity of 30%~ 70%.
在30%～70%的相对湿度范围，使用摩擦系数测定仪，研究了玻璃表面和玻璃基体上纳米二氧化钛光致双亲性膜的摩擦系数与紫外光和环境湿度的变化规律。 - We also find that, due to the water vapor condensation, the adhesive force and friction coefficient on sample surfaces increase first, then decrease with the relative humidity increase.
由于强的亲水性，样品表面的摩擦系数和黏附力随着湿度的增大先逐渐增大，然后急剧减小。 - With the increase of the concentrations of peroxide solutions, the degree of adhesive wear weakened and the friction coefficient decreased. In high concentration of peroxide solutions, the main wear mechanism of ceramic materials was corrosive wear, abrasive wear and the friction coefficient increased.
随着H202介质溶液浓度的增大，粘着作用减弱，摩擦系数减小，高浓度H202介质溶液中，Si3N4陶瓷材料的磨损以腐蚀磨损和磨粒磨损为主，摩擦系数增大。 - The total adhesive friction coefficient is expressed as a combination of adhesive friction coefficients in elastic and plastic contact regime.
总的粘着摩擦系数被表示为弹性接触区与塑性接触区的粘着摩擦系数的组合。 - The mechanism shows hysteresis friction at low load while adhesive friction at high load.
在较低载荷时，丁腈橡胶表现为滞后摩擦，在较高载荷时，表现为粘着摩擦； - On adhesive friction coefficient with fractal geometry
粘着摩擦系数的分形几何研究 - The main wear mechanisms of nylon 1010 composites are fatigue fracture and adhesive wear and it can be observed that the GF is rubbed, fractured and peeled off under dry friction condition.
干摩擦下的复合材料磨损以疲劳断裂和粘着为主，且纤维出现磨损、断裂及从基体中剥落的现象。 - This paper sets up a mathematical model for calculating thermal balance of plunger-cylinder wall friction pair in axial plunger pump, analyzes the cause of producing adhesive wear on the friction pair, and puts forward a way to solve the problem.
本文提出了轴向柱塞泵柱塞&缸孔摩擦副热平衡计算的数学模型，进而分析了这对摩擦副产生粘着磨损的原因，并提出了解决办法。 - Assuming that the yield pressure and the local adhesive friction coefficient are independent on the contact spot and equal to the average values in the plastic contact regimes, the total adhesive friction coefficient is given by simple formulae.
假设屈服压力及局部粘着摩擦系数不依赖于接触斑点且等于塑性接触区中的平均值，则总的粘着摩擦系数可用简单的表达式描述。 - Friction characteristics of PC and its alloys can be explained by adhesive friction theory, and wear of these materials are controlled by adhesive, abrasive and fatigue wear mechanisms.
聚合物及其合金的摩擦特性可由粘着摩擦理论解释，其磨损过程主要受粘着、磨粒和疲劳机理控制。